全部

力学与实践 ›› 2009, Vol. 31 ›› Issue (3): 52-56.doi: 10.6052/1000-0879-2008-273

• 应用研究 • 上一篇    下一篇

用于聚合物驱油的抽油杆动力学分析

朱君 辛旻 秦庆忠 董海洋   

  1. 大庆石油学院机械系 黑龙江 大庆 163318
  • 收稿日期:2008-05-20 修回日期:2008-06-18 出版日期:2009-06-08 发布日期:2009-06-08

DYNAMIC ANALYSIS OF THE SUCKER ROD IN THE POLYMER FLOODING METHOD$

  • Received:2008-05-20 Revised:2008-06-18 Online:2009-06-08 Published:2009-06-08

摘要: 聚驱井与水驱井相比杆管偏磨更加严重,聚驱井采出液的法向力是加剧偏磨 的重要因素之一. 根据非牛顿流体力学理论,采用上随体Maxwell模型,建立了法向力计算 模型,确定了井筒内法向力的分布规律,并将此法向力施加在抽油杆的瞬态动力学 模型中; 考虑实际边界条件,采用有限元法对聚驱抽油杆进行了分析计算. 并对FU081801 井模拟计算进行验证,模拟结果与作业检测结果吻合较好,证明了该方法的可行性. 通过此 方法可预测出聚驱井杆管的偏磨位置以及聚合物浓度对抽油杆偏磨的影响程度.

关键词: 聚驱井;抽油杆;法向力;力学行为;偏磨

Abstract: The eccentric wearing of a sucker rod in polymer flooding is much more serious than that in water flooding, mainly due to the normal force of production liquid in polymer flooding. Based on the non-Newtonian fluid mechanics theory, a normal force computational model is established using the upper-convected Maxwell model, and the distribution of the normal force inside the well is confirmed and then put into the mechanical model of the sucker rod. With the real boundary condition, the analysis of the sucker rod is carried out using the finite element method. With Well FU081801 as an example simulation method is validated. The simulation result agree with the detection result, which demonstrates the applicability of this method. Through the method, we can predict the eccentric wearing position of the rods and tubes, as well as the influence of polymer concentration on the eccentric wearing of the sucker rod.

Key words: polymer flooding well, sucker rod, normal force, kinetic behaviour, eccentric wearing